Kitchen Cabinets. Friday , December 29th , 2017 - 12:52:57 PM
2. Now that you have the top of the base cabinets marked, measure up another 19 1/2 inches and a level line across the wall to indicate the bottom of the wall cabinets. Lightly mark each cabinets dimensions and placement on the wall to make sure that your original layout is correct. 3. Use a stud finder to locate the wall studs. Use a pencil to mark the stud locations at least 6 inches above and below the line for the bottom of the wall cabinets. Draw straight vertical lines between the top and bottom marks to indicate the center of the studs. 4. If you decided to go with the piece of 1 x 3 lumber, now is where you will use (if you decided to go with the U-shaped frame, it will come into play after all your lines are laid out). Screw a temporary 1 x 3 support rail to the wall, aligning the top edge of the rail with the line for the bottom edge of the wall cabinets. Attach it by driving 3 or 4 two inch screws through the rail into the wall studs. 5. Now that we have all the lines marked, it is time to start installing your kitchen cabinets.
9. If your cabinets end up butting against another wall, you may need a filler strip to make up the last few inches. If you have custom cabinets, they should have been built to fill this gap, but if you are using stock or RTA Kitchen Cabinets the filler strip may be needed. If you do need to use a filler strip, leave the last cabinet detached from the other cabinets. Clamp a straightedge to the face of the nearest installed unit, extending far enough for you to put alignment marks on the end wall. Allow a 3/4" offset behind those marks (for the thickness of the filler piece) and fasten a cleat to the wall. Then install and fasten the last cabinet and measure the gap between its face frame and the wall.
Adding molding to the cabinet is an easy way to make any kind of cabinet look custom. Adding crown molding to an existing kitchen or edge molding to new cabinets will help the kitchen look more elegant and rich. It is a great addition to do after buying new cabinets for the kitchen. Decorative supports, aprons, and corbels are great extra features to add to cabinets. They are not standard on most cabinets, but are a great project to add on to the kitchen after installation of the new cabinet. Decorative supports put an artful emphasis on upper cabinets. The supports were originally designed to help support cabinets, but now they only serve as decor. Corbels are a great focal point to add to make a kitchen more elegant. They work best in island corners. They are very ornate and stand out on kitchen cabinets to draw attention to certain features. The apron is a piece of wood that travels under and around the countertop overhang. A standard apron height is three inches to leave room for legs under the countertop.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does usssantafe claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.