Kitchen Cabinets. Friday , December 29th , 2017 - 12:59:38 PM
Use shims where needed to level the cabinet and raise it up to the line which indicates the high point of the floor. Be sure it is level from front to back and from side to side, then screw it to the wall studs. If you dont have a diagonal corner cabinet or blind base cabinet in the corner, push the adjoining cabinet into place and clamp the two units together. Add a filler strip if needed to allow the doors and drawers enough clearance to open and close properly. If necessary, tap shims under the cabinet and behind it to adjust for plumb and level. 8. Drive screws through the cabinet back (and shims) into the wall studs. Trim any excess material from the shims with a sharp chisel or knife. Continue to add adjoining cabinets in this manner, joining them the same way you connected the wall cabinets in step 6.
· Semi-custom kitchen cabinets: These are similar to stock cabinets but are usually produced per order, and homeowners can order for basic changes in size or choose from a wide range of molding, trims and finishes. · Stock kitchen cabinets: These are mass-produced kitchen cabinet models that install easily; however, they cant be modified to your individual taste unless your either stain or repaint them. These cabinets should therefore not be an option for those who wish to change the look of their kitchen cabinets in the future after installing them. The main advantages of considering these cabinets are that they install easily and are cheap and readily available.
Custom Kitchen Cabinets Custom kitchen cabinets are cabinets that are built just for your kitchen layout, design taste and needs. Custom kitchen cabinetry can easily be built to fit between two walls or to match odd angles, something not possible with stock kitchen cabinets. There are many advantages with custom cabinets that can not be had with stock cabinetry. The advantages that are at the top of the list are selection. Since a custom cabinet maker will be producing your new kitchen cabinets you can have them make just about any style that is imaginable. You can also have them produce cabinets that are in rare or exotic woods. You can also have a much larger selection of cabinet doors and drawer fronts. Some custom cabinet makers do opt to outsource their doors and drawer fronts, in this case they will usually have a very large catalog of doors for you to make your selection. With custom built cabinets you can select the type of hardware such as cabinet door hinges as well as drawer slides. Most are currently opting for hinges and drawer slides with the soft close feature. This is not only very popular but I wouldnt be surprise if this becomes the standard in the next few years.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does usssantafe claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.