Kitchen Cabinets. Friday , December 29th , 2017 - 13:26:02 PM
Adding molding to the cabinet is an easy way to make any kind of cabinet look custom. Adding crown molding to an existing kitchen or edge molding to new cabinets will help the kitchen look more elegant and rich. It is a great addition to do after buying new cabinets for the kitchen. Decorative supports, aprons, and corbels are great extra features to add to cabinets. They are not standard on most cabinets, but are a great project to add on to the kitchen after installation of the new cabinet. Decorative supports put an artful emphasis on upper cabinets. The supports were originally designed to help support cabinets, but now they only serve as decor. Corbels are a great focal point to add to make a kitchen more elegant. They work best in island corners. They are very ornate and stand out on kitchen cabinets to draw attention to certain features. The apron is a piece of wood that travels under and around the countertop overhang. A standard apron height is three inches to leave room for legs under the countertop.
As I mentioned above, you have the option of using a piece of 1 x 3 lumber for the installation or building a frame to support the cabinets (I have included a picture of a sample frame below). This can be made out of 2x 4s and should be tall enough to support the bottom of your wall cabinets. If you plan on installing more than one kitchen, then I would suggest the frame, but a piece of lumber will do just fine if this is a one time event. In either case, you will need another set of hands to help with the installation.
Now that you have your new kitchen cabinets, you are ready to move on to the next big step.....Installing your kitchen cabinets. While the actual installation of the Kitchen Cabinets isntall that hard, the critical first step is measuring and marking out where the cabinets will go. By placing layout markings on the walls and floors, it will not only help you with kitchen cabinet placement and stud locations, but it will also help you locate where adjustments and shims will be required. Before we get started there are a couple of items that you will need for the project: Pencil Level or Laser Level Drill Tape Measure Stud Finder Clamps 1" x 3" Piece of lumber (6-8 in length) or an Inverted U-shaped frame (see notes below) Shims Screws (long enough to go 1 1/2 into the studs) Utility knife or chisel Marking Compass An extra set of hands (you may have to bribe one of your friends).
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does usssantafe claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.