Kitchen Cabinets. Friday , December 29th , 2017 - 13:07:13 PM
9. If your cabinets end up butting against another wall, you may need a filler strip to make up the last few inches. If you have custom cabinets, they should have been built to fill this gap, but if you are using stock or RTA Kitchen Cabinets the filler strip may be needed. If you do need to use a filler strip, leave the last cabinet detached from the other cabinets. Clamp a straightedge to the face of the nearest installed unit, extending far enough for you to put alignment marks on the end wall. Allow a 3/4" offset behind those marks (for the thickness of the filler piece) and fasten a cleat to the wall. Then install and fasten the last cabinet and measure the gap between its face frame and the wall.
In the event that you think this is a project that you are comfortable tackling, you can either use a kitchen designer or go to one of the home improvement centers and take advantage of their free design services. There are several factors that are going to affect the cost of your cabinets: cabinet brand, construction, wood type, and features. It is important to research all of your options. What you will find is that a higher price doesnt always correspond with higher quality, and some of the lesser-known cabinet lines will actually have a stronger construction.
Use shims where needed to level the cabinet and raise it up to the line which indicates the high point of the floor. Be sure it is level from front to back and from side to side, then screw it to the wall studs. If you dont have a diagonal corner cabinet or blind base cabinet in the corner, push the adjoining cabinet into place and clamp the two units together. Add a filler strip if needed to allow the doors and drawers enough clearance to open and close properly. If necessary, tap shims under the cabinet and behind it to adjust for plumb and level. 8. Drive screws through the cabinet back (and shims) into the wall studs. Trim any excess material from the shims with a sharp chisel or knife. Continue to add adjoining cabinets in this manner, joining them the same way you connected the wall cabinets in step 6.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does usssantafe claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.